The Shred School 101 book is here · PDF $9.99 · Paperback on Amazon →

IntermediateFreestyleFreestyle

How to Primo Slide

A heel-side railstand done as a slide while rolling on flat ground.

Written guide. There's no video for this one yet, so it's step by step in text below.

A primo slide is a heel-side railstand done as a slide on flat ground. It was invented by, and named for, Primo Desiderio, a big freestyle skater in the ’80s. A lot of beginners call a stationary railstand a “primo,” but that’s like saying “50-50 stall” instead of “axle stall.”

Railstands are the most important freestyle trick to learn, and this is how to do them while rolling.

Before you start

Get comfortable with stationary railstands first.

Find the smoothest, slickest surface you can skate. Polished concrete or skatelite at an indoor skatepark would be best by far, but this trick should technically be possible anywhere.

Foot position

  • Front foot: angled almost parallel to the edge of the board, with a lot of pressure on your toe.
  • Back foot: on the bolts, with a lot of your toe hanging off so you’re ready to land on the wheel once the board tips over. Curl your toes over the edge to get them as close to the ground as possible.

How to primo slide

1. Get the board on its edge

Flipping the board up onto its edge takes both feet. Put sharp pressure on your front foot while hopping slightly, and when the board starts to tip, use your back foot to pull it up onto its side. Your back foot never actually loses contact with the board during the transfer.

2. Lean back

Depending on your speed and the surface, you’ll also have to push the board out ahead of you so you’re leaning back in the slide. Otherwise the axles catch and you get thrown off.

3. Ride it out

Once both feet are in position, ride out your momentum as long as you can.

4. Tip it back over

When you’ve lost most of your speed, push the board forward with both feet at the same time and it should tip back onto its wheels. If you’ve come this far, this part is pretty simple.

Troubleshooting

Still sticking on a slick surface

Put wax on the side of your deck and on your axles. It won’t do much, but it helps a little.

What’s next

Once you’re landing primo slides, try 180s while sliding, or try flipping out of them with a railflip. Eventually you might be able to do them on a manual pad like Rodney Mullen.

Primo Slide FAQ

What's the difference between a primo slide and a railstand?

A primo slide is a heel-side railstand done as a slide while rolling. Calling a stationary railstand a primo is like saying 50-50 stall instead of axle stall.

Where should I learn primo slides?

The smoothest, slickest surface you can find. Polished concrete or skatelite at an indoor park is best by far.

Why does my board stop dead in a primo slide?

The axles are catching. Push the board out ahead of you so you're leaning back in the slide. Wax on the side of the deck and the axles helps a little too.

Skate at your own risk. Wear a helmet and pads, and work up to tricks at your own pace. Terms

All 65 tricks · Trick tree · Freestyle playlist on YouTube

Your cart

Your cart is empty. Browse the shop.